Microswitch Kit, Quick Connect for Universal Control Head - B-87-030 - Industry & Range Guard (wet & dry chemical)
B-87-030

The Quick Connect Microswitch used with the Universal Control Head is a single pole, double-throw switch. Included in the microswitch kit is the microswitch, pigtail assembly, mounting screws, and wiring diagram label. Microswitch Kit P/N 87-120039-001 includes a pigtail assembly with solid color leads. Microswitch Kit P/N 87-120039-501 includes a pigtail assembly with striped leads. All wire leads are 24 inches (610 mm) in length.

Quick Connect Microswitches are used to open or close electrical circuits, including, but not limited to:

• Electric appliance shutdown
• Make-up air shutdown
• Electric gas valve shutdown
• Shuntbreaker/relay

Electrical appliances typically have higher amp ratings than those of the microswitches.

In this case, appliances shall not be wired directly to the microswitch. A magnetic contactor or relay must be used. For wiring the microswitch with the Universal Control Head.

Quick Connect Microswitch Kits are not for alarm initiation or solenoid release. A separate Alarm/Release Terminal Type Microswitch (P/N 87-120047-001) is available.

The Universal Control Head has two separate microswitch mounting locations to support up to four (4) microswitches (any combination of Quick Connect and/or Alarm/Release type). Each of the two mounting locations has a corresponding EMT port for wire leads, allowing the use of two electrical junction boxes for separation of signal lines and AC lines.

• Quick Connect Microswitch Kit, SPDT, Solid Leads 87-120039-001

• Quick Connect Microswitch Kit, SPDT, Striped Leads 87-120039-501

• Universal Control Head 60-120099-002

• EMT Connector Kit (set of 3) 87-120058-001

• Alarm/Release Terminal Type Microswitch 87-120047-001

Badger is a registered trademark of Kidde-Fenwal, Inc. Range Guard is a registered trademark of Badger Fire Protection. Industry Guard is a trademark of Badger Fire Protection.

This literature is provided for informational purposes only. BADGER FIRE PROTECTION assumes no responsibility for the product’s suitability for a particular application. The product must be properly applied to work correctly.