Alarm/Release Terminal Type Microswitch - 87-120047-001 - Industry & Range Guard (wet & dry chemical)
87-120047-001

The microswitch kit (P/N 87-120047-001) includes the switch, non-conductive shield and mounting hardware.

The Alarm/Release microswitch provides approved supervision for the alarm zone circuit of the Kidde AEGIS™ and ARIES™panels, and for other UL Listed control panels (Figure 2). The switch can also be wired in series with the Universal Control Head Solenoid Electric Actuator (P/N 83-100034-001) to open the releasing loop upon system actuation (Figure 3).

Alarm/Release Terminal Type Microswitches are not used for electrical shutdown (i.e., appliance, gas, makeup air). Quick Connect Microswitch Kits (P/Ns 87-120039-001 and 87-120039-501) are available for shutdowns. The Universal Control Head has two separate micro switch mounting locations to support up to four (4) micro switches (any combination of Quick Connect and/or Alarm/Release type). Each of the two mounting locationshas a corresponding EMT port for wire leads, allowing the use of two electrical junction boxes for separation of signal lines and AC lines.

• For use in both Range Guard® Commercial Cooking Fire Suppression Systems and Industry Guard™ Industrial Fire Suppression Systems

• Used for Alarm Circuit and Release Circuit

• Screw-type Terminals for Secure Wire Mounting

• For Use with Universal Control Head (UCH)

• Meets Alarm Requirements for CSA (Canada)

• Stackable with Quick Connect Universal Control Head Microswitch

• Ships with Non-Conductive Barrier

ORDERING INFORMATION

• Alarm/Release Terminal Type Microswitch 87-120047-001

• Universal Control Head 60-120099-002

• Universal Solenoid Electric Actuator Kit 83-100034-001

• EMT Connector Kit (set of 3) 87-120058-001

• Quick Connect Microswitch Kit, Solid Leads 87-120039-001

• Quick Connect Microswitch Kit, Striped Leads 87-120039-501

Badger and Kidde registered trademarks of Kidde-Fenwal, Inc. Range Guard is a registered trademark of Badger Fire Protection. AEGIS and ARIES are trademarks of Kidde-Fenwal, Inc. Industry Guard is a trademark of Badger Fire Protection.

This literature is provided for informational purposes only. BADGER FIRE PROTECTION assumes no responsibility for the product’s suitability for a particular application. The product must be properly applied to work correctly.